 |
An exhaust riser raises the level of the exhaust elbow. This is installed on vessels with engine installations at or below the water line. The riser …
|
|
 |
An extremely flexible exhaust hose for marine wet exhaust systems that conforms with ISO13363 type 2 (+580°C) and SAE J 2006 type R2. The minimized bend radius means easy and quick installation. Reinforced by synthetic textile layers and embedded steel wire helix it has plain and smooth inner …
|
|
 |
The standard exhaust fitting for I/Oengines leads the exhaust through the drive. If a separate silencer is required, then the exhaust port in the transom shield must be sealed.Includes:Cover platefittings.
|
|
 |
The silencer effectively silences engine exhaust noise with a minimum of back pressure. The silencer also functions as an effective water-lock. The large capacity for cooling water eliminates the risk of water siphoning back into the engine when stopped. Adjustable mounting brackets make the …
|
|
| |
The temperature alarm sensor is installed in the exhaust hose and transmits a signal to a warning lamp in the event of excessive exhaust temperatures as a result of water shortage.Includes: Sensor, cables.
|
|
 |
Through-hull exhaust fitting with drip-edge to prevent cooling water from discoloring the side of the hull. With preformed collar for hose connection. Supplied complete with hose clips.
|
|
 |
This exhaust elbow is used in conjunction with dry exhaust systems where the cooling water does not mix with the exhaust gases. The elbow is mounted on the turbo flange and can be turned to the desired position. One section of the elbow is flexible and prevents vibration and heat being transferred …
|
|
 |
In order to comply with strict regional noise limitation requirements, Volvo Penta has developed exhaust cover kits for shields and drives. The kits are intended for 3.0 and 4.3 gasoline engines with SX drive.
|
|
 |
The engine brackets are designed for engine installations at or below the water level in, for example, long-keeled hulls. With raised brackets, the engine pads are moved 14 mm outwards (from engine), 19 mm backwards and 40 mm upwards. Material: Sheet steel
Surface treatment: Green paint
Includes: …
|
|
| |
Protects against water entry. The kit includes nuts and bolts for attaching the drip pan to the air filter housing.
|
|
